Leading Manufacturer for PA/VA System

www.dsppatech.com

Search

Hidden Wall Speakers

DSP40IL 40W Hidden In Wall speakers
Rate power 40W,8 Ω speaker input available
CE&UL certificated, safe & stable
Wide Freq. Response: 100Hz -20 kHz...

Send Inquiry Chat Now

Features

Rate power 40W,8 Ω speaker input available

CE&UL certificated, safe & stable

Wide Freq. Response: 100Hz -20 kHz

Max SPL:102±2dB

High sensitivity:87±2dB

Totally invisible, installed in the wall or ceiling

Excellent sound quality, for installation in high-end places


Description

The DSP40IL is a in-wall or in-ceiling speaker of 8 Ω speaker input.

Thanks to the special driver unit and special material used in the surface cover, DSP410I can perform with wonderful sound when it is installed inside the wall or ceiling.

Totally invisible. When installed in the wall or ceiling and furnished with paint, the DSP40I can be integrated with the surrounding and be totally invisible.

It is ideal choice for industrial and commercial applications in shopping malls, office building and museums where background music and paging is needed.


Specification

Model

DSP40IL

Rated Power

40W

Line Voltage

100V

Sensitivity(1M,1W)

87±2dB

Max SPL(1M)

102±2dB

Freq. Resp

100Hz-20kHz

Net Weight

1.2 kg

Size

300mm×400mm×50mm


Performance

TIM截图20180427105324.jpg

Installation

1、Cut a small aperture where needed to install and measure the distance between the frames; make sure there is enough space to avoid the frame behind the wall in order to put the back cover in.

2、Mark lines to confirm the position with the additional cardboard (304mm×404mm).

3、Cut the aperture according to the marked lines by a saw or knife

4、Pull the audio line through the hole of back cover.

5、Put one side of back cover into the hole then put the whole back cover.

6、Fasten down the installation surface and back cover as figure B (each side fasten 4 additional screws, totally 8).

7、C onnect the audio wire to the terminal of speaker.

8、Push the surplus audio wire out to avoid getting in touch of speaker’s back.

9、Connect the speaker to the back cover; make sure there is 2mm distance between the speaker and the edge and whether the speaker is at the same level.

10、 Please test the speaker immediately: first of all check the impedance on the other side, then test audio frequency with scanning signal in order to confirm whether there are noises from the surface of speaker, back cover or neighboring surface.

11、Putty the crack between the speaker and the installation surface.

12、Cover speaker and the crack with seaming mesh.

13、Paint a 2mm depth putty on the whole installation surface.

14、Test speaker once again.

15、fter the test is over and when your plasterwork is completely dry, decorate the surface of the plaster with paint, wallpaper, fabric or other coatings as required.


image011.jpgimage009.jpgimage010.jpgimage013.jpg


Related Products